Geometrical Product Specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out

International Organization for Standardization. (2012). Geometrical Product Specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out.

Type

Standard

Intellectual base

Reference work

Year

2012

Link

https://www.iso.org/standard/59490.html

Cited from

engineering_design

Cited by

1 citation across 1 artifact.

Primes

• Engineering Tolerances
  • Listed in the references but not attached to a specific claim.

Verification

Does it exist? Not checked yet. This entry carries no identifier to resolve. It was extracted from the citation as written in the article, normalized, and deduplicated against the rest of the registry.

Does it back the claim? Not recorded. The single citation of this work carries no recorded support check.

Support is checked per citation rather than per work — the same source can be cited soundly in one article and wrongly in another. Per-citation recording began recently, so a citation with no recorded check is a gap in the record rather than evidence it went unchecked.

See how references were verified.

Registry ID ref:06da6b9261cf · see in the full table