Design for additive manufacturing¶
Thompson, M. K., Moroni, G., Vaneker, T., Fadel, G., Campbell, R. I., Gibson, I., Bernard, A., et al. (2016). Design for additive manufacturing: trends, opportunities, considerations, and constraints. CIRP Annals - Manufacturing Technology, 65(2), 737-760.
Cited by¶
1 citation across 1 artifact.
Each citation links to the sentence it supports in the citing article.
Mechanisms¶
- Additive Lattice or Gyroid Fabrication
- The as-built network is never quite the as-designed one: down-facing struts sag, thin walls thicken with adhered powder, and any feature below the machine's self-supporting overhang angle degrades or fails to form.
This sourceDocuments process-dependent deviations in additively manufactured parts and shows that unsupported features can fail unless orientation and support strategy fit the machine and process.
- The as-built network is never quite the as-designed one: down-facing struts sag, thin walls thicken with adhered powder, and any feature below the machine's self-supporting overhang angle degrades or fails to form.
Verification¶
Does it exist? Confirmed. This work's DOI resolves to a registered record, which fixes its identity. That is all it fixes.
Does it back the claim? Not recorded. The single citation of this work carries no recorded support check.
Support is checked per citation rather than per work — the same source can be cited soundly in one article and wrongly in another. Per-citation recording began recently, so a citation with no recorded check is a gap in the record rather than evidence it went unchecked.
See how references were verified.
Registry ID ref:1235f8b15c13 · see in the full table