M540 - Endstops Abort SD¶
Marlin firmware project. (2026). M540 - Endstops Abort SD.
Cited by¶
1 citation across 1 artifact.
Each citation links to the sentence it supports in the citing article.
Domain-specific¶
- Endstop-triggered machine interruption
- An enabled limit or endstop sensor is hit; the controller recognizes that event and interrupts the operation in its configured way.
This sourceFirst-party firmware documentation; cited for the SD-print abort option, build features and enabled-endstop condition. This is a described configuration, not an observed printer run.
- An enabled limit or endstop sensor is hit; the controller recognizes that event and interrupts the operation in its configured way.
Verification¶
Does it exist? Not checked yet. This entry carries no identifier to resolve. It was extracted from the citation as written in the article, normalized, and deduplicated against the rest of the registry.
Does it back the claim? Not recorded. The single citation of this work carries no recorded support check.
Support is checked per citation rather than per work — the same source can be cited soundly in one article and wrongly in another. Per-citation recording began recently, so a citation with no recorded check is a gap in the record rather than evidence it went unchecked.
See how references were verified.
Registry ID ref:2f8ab4f6afd7 · see in the full table