ISO System of Limits and Fits

International Organization for Standardization. (1988). ISO System of Limits and Fits.

Type

Standard

Intellectual base

Reference work

Year

1988

Link

https://www.iso.org/standard/4202.html

Cited from

engineering_design

Cited by

1 citation across 1 artifact.

Each citation links to the sentence it supports in the citing article.

Primes

• Engineering Tolerances
  • The specification pattern replacing a single nominal value with an interval (nominal ± limits) treating all values in the interval as conforming

    This sourceCode system of tolerance grades and fundamental deviations for holes and shafts — supports the interval-replaces-nominal specification pattern (D34-032) and the component-tolerance-vs-supplier-capability tension via standard fits (D34-040).

Verification

Does it exist? Not checked yet. This entry carries no identifier to resolve. It was extracted from the citation as written in the article, normalized, and deduplicated against the rest of the registry.

Does it back the claim? Not recorded. The single citation of this work carries no recorded support check.

Support is checked per citation rather than per work — the same source can be cited soundly in one article and wrongly in another. Per-citation recording began recently, so a citation with no recorded check is a gap in the record rather than evidence it went unchecked.

See how references were verified.

Registry ID ref:34693871cf96 · see in the full table