Experimental and Numerical Investigation of the Die Swell in 3D Printing Processes

De Rosa, S., Tammaro, D., & D’Avino, G. (2023). Experimental and Numerical Investigation of the Die Swell in 3D Printing Processes. Micromachines, 14(2), 2-2.

Type

Journal article

Intellectual base

Primary research

Year

2023

Volume

14

Issue

2

Pages

2-2

DOI

10.3390/mi14020329

DOI registrant

MDPI AG

Link

https://doi.org/10.3390/mi14020329

Cited by

1 citation across 1 artifact.

Domain-specific

• Die Swell
  • A slit die calls for separate width and edge-height ratios: the measured width can grow while the edge height contracts.

Verification

Does it exist? Not checked yet. This work's DOI is recorded above but has not been resolved against an external catalogue, so nothing here confirms the work exists.

Does it back the claim? Not recorded. The single citation of this work carries no recorded support check.

Support is checked per citation rather than per work — the same source can be cited soundly in one article and wrongly in another. Per-citation recording began recently, so a citation with no recorded check is a gap in the record rather than evidence it went unchecked.

See how references were verified.

Registry ID ref:4c06a70c23b6 · see in the full table