Die swell of Polypropylene flow through a slit die, experiment and 3D simulation¶
Tang, D., Van Puymbrouck, N., Marchesini, F. H., & Cardon, L. (2018). Die swell of Polypropylene flow through a slit die, experiment and 3D simulation.
Cited by¶
1 citation across 1 artifact.
Each citation links to the sentence it supports in the citing article.
Domain-specific¶
- Die Swell
- A slit die calls for separate width and edge-height ratios: the measured width can grow while the edge height contracts.
This sourceThe linked title transcribes the original colon before “experiment” as a comma. The authors define separate slit-width and edge-height ratios, report width growth with edge-height decrease, and compare PTT with Cross-law simulation.
- A slit die calls for separate width and edge-height ratios: the measured width can grow while the edge height contracts.
Verification¶
Does it exist? Not checked yet. This entry carries no identifier to resolve. It was extracted from the citation as written in the article, normalized, and deduplicated against the rest of the registry.
Does it back the claim? Not recorded. The single citation of this work carries no recorded support check.
Support is checked per citation rather than per work — the same source can be cited soundly in one article and wrongly in another. Per-citation recording began recently, so a citation with no recorded check is a gap in the record rather than evidence it went unchecked.
See how references were verified.
Registry ID ref:58be33ff669e · see in the full table