Dimensioning and Tolerancing¶
American Society of Mechanical Engineers. (2018). Dimensioning and Tolerancing.
Cited by¶
3 citations across 3 artifacts.
Each citation links to the sentence it supports in the citing article.
Primes¶
- Engineering Tolerances
- The distinction between bilateral tolerances (nominal ± limit), unilateral tolerances (nominal + upper or lower limit only), and asymmetric tolerances
This sourceAuthoritative GD&T standard defining symbols and rules for dimensional and geometric tolerancing — supports the bilateral/unilateral/asymmetric tolerance distinction (D34-036) and the bilateral-vs-unilateral-vs-asymmetric tension (D34-042).
- The distinction between bilateral tolerances (nominal ± limit), unilateral tolerances (nominal + upper or lower limit only), and asymmetric tolerances
Mechanisms¶
- Dimensional Chain Diagram
- Anchoring to a shared datum reference — the discipline formalized in geometric dimensioning and tolerancing — is what keeps one feature's deviation from cascading through the whole chain.
This sourceDefines ASME Y14.5 as the authoritative standard for geometric dimensioning and tolerancing, including datum references used to locate and orient features.
- Anchoring to a shared datum reference — the discipline formalized in geometric dimensioning and tolerancing — is what keeps one feature's deviation from cascading through the whole chain.
- Engineering Tolerance Specification
- Formal geometric dimensioning and tolerancing gives it a grammar
This sourceDefines the symbols and rules that form GD&T's design language.
- Formal geometric dimensioning and tolerancing gives it a grammar
Verification¶
Does it exist? Not checked yet. This entry carries no identifier to resolve. It was extracted from the citation as written in the article, normalized, and deduplicated against the rest of the registry.
Does it back the claim? Not recorded. Neither this nor any other of the 3 citations of this work carries a recorded support check.
Support is checked per citation rather than per work — the same source can be cited soundly in one article and wrongly in another. Per-citation recording began recently, so a citation with no recorded check is a gap in the record rather than evidence it went unchecked.
See how references were verified.
Links previously used in the corpus¶
Before the registry existed this work was also linked 2 other ways.
- https://www.asme.org/codes-standards/find-codes-standards/dimensioning-and-tolerancing ×1
- https://www.asme.org/codes-standards/find-codes-standards/y14-5-dimensioning-tolerancing ×1
Registry ID ref:8b0623106faa · see in the full table