Using Side-Actions in Molding Design¶
Protolabs. Using Side-Actions in Molding Design.
Cited by¶
1 citation across 1 artifact.
Each citation links to the sentence it supports in the citing article.
Domain-specific¶
- Manufacturing Undercut
- A side hole that traps a mold surface under the primary opening direction and a recessed surface hidden from an ordinary straight milling approach are distinct process realizations of this geometric obstruction.
This sourceFirst-party injection-molding guidance for straight-pull obstruction and retracting side actions.
- A side hole that traps a mold surface under the primary opening direction and a recessed surface hidden from an ordinary straight milling approach are distinct process realizations of this geometric obstruction.
Verification¶
Does it exist? Not checked yet. This entry carries no identifier to resolve. It was extracted from the citation as written in the article, normalized, and deduplicated against the rest of the registry.
Does it back the claim? Not recorded. The single citation of this work carries no recorded support check.
Support is checked per citation rather than per work — the same source can be cited soundly in one article and wrongly in another. Per-citation recording began recently, so a citation with no recorded check is a gap in the record rather than evidence it went unchecked.
See how references were verified.
Registry ID ref:8e1c348a2a54 · see in the full table