Computer-Aided Tolerancing¶
Bjørke, Ø. (1989). Computer-Aided Tolerancing. ASME Press.
Cited by¶
1 citation across 1 artifact.
Each citation links to the sentence it supports in the citing article.
Primes¶
- Engineering Tolerances
- The relationship between component tolerances and system reliability: manufacturing variation compounded across multiple components produces system variation that must remain within acceptable limits
This sourceTreats tolerance chains, process parameters, tolerance-cost models, and tolerance distribution — supports the component-tolerance-to-system-reliability relationship (D34-037) and the formal example's geometric/statistical stack-up formalization (D34-038).
- The relationship between component tolerances and system reliability: manufacturing variation compounded across multiple components produces system variation that must remain within acceptable limits
Verification¶
Does it exist? Not checked yet. This entry carries no identifier to resolve. It was extracted from the citation as written in the article, normalized, and deduplicated against the rest of the registry.
Does it back the claim? Not recorded. The single citation of this work carries no recorded support check.
Support is checked per citation rather than per work — the same source can be cited soundly in one article and wrongly in another. Per-citation recording began recently, so a citation with no recorded check is a gap in the record rather than evidence it went unchecked.
See how references were verified.
Registry ID ref:f53cc42c122c · see in the full table